From: KatJoyWhite Date: Sun, 9 Dec 2012 12:17:31 +0000 (+0000) Subject: Update README.md X-Git-Url: https://git.njae.me.uk/?a=commitdiff_plain;h=382c64a9afe7a2ca25a7a09adab91bbcaaa131ee;hp=8d4c82f4ccbd77b3b67a4e1783ef287727a272eb;p=miniband.git Update README.md --- diff --git a/README.md b/README.md index eece95b..44ed82b 100644 --- a/README.md +++ b/README.md @@ -37,6 +37,19 @@ Learn how to build circuits with sensors and outputs and write a simple programm ## Useful links: * [Pictures](http://bit.ly/codeclubminiband) +* [Ardunio code](https://github.com/KatJoyWhite/miniband/tree/master/arduino) + + + +## Pull-down Resistors + +You’ll find your analogue inputs receive signal when you don’t expect them to. +This is because there’s electricty floating around in the system, or something like that. + +To fix this, you need to wire each input to ground, through a 10KΩ resistor. + +A better explanation can be found [here](http://arduino.cc/en/Tutorial/DigitalPins). + ## Drum Kit @@ -55,7 +68,7 @@ Repeat for each of your drums. It is easiest to use a bread board for making you Look at the picture for an example. -### 3. Progam the Arduino +### 3. Program the Arduino Find the appropriate code from the respository and upload to your Ardunio board. @@ -84,8 +97,15 @@ the fretboard runs (high and the top, low at the bottom or vice-versa). Signal will come from the centre pin, so connect that to one of your analogue inputs and you should be good to go. -### 3. Set up in Scratch +### 3. Program the Arduino + +Find the appropriate code from the respository and upload to your Ardunio board. + + +### 4. Set up in Scratch + +Find five different guitar sounds and upload to Scratch. ## Maracas @@ -105,14 +125,13 @@ Connect the +5V port on the Arduino board to one of the pins on the tilt switch Connect the other pin to an empty digital input on the board. -### 3. +### 3. Program the Arduino + +Find the appropriate code from the respository and upload to your Ardunio board. -## Pull-down Resistors +### 4. Set up in Scratch -You’ll find your analogue inputs receive signal when you don’t expect them to. -This is because there’s electricty floating around in the system, or something like that. +Find a maraca / shaker sound and upload to Scratch. -To fix this, you need to wire each input to ground, through a 10KΩ resistor. -A better explanation can be found [here](http://arduino.cc/en/Tutorial/DigitalPins).